Please note (Disclaimer) > Please read carefully. The store is not responsible for any accidents or damages resulting from the use of this product.
Thank you for your understanding.
Instruction manual and warranty are not included.



Sheet metal tools, dent repair, dent restoration tools
A must-see for professionals.
A set of 100 flat washers and 6-claw and 7-claw puller hooks, a must-see for professionals. Please use for sheet metal work on automobiles, etc.
We have prepared flat washers and 6-claw and 7-claw puller hooks.
Our flat washers and puller hooks are 100% compatible in size, so please use them.


Product Introduction

This is a useful item for pulling out dented areas of automobiles all at once. We have prepared a set of 100 flat washers that correspond to the 6-claw and 7-claw puller hooks for pulling.
Flat washers are available in a set of 100 for easy purchase as needed.
The flat washers are made of steel with copper plating, which reduces material deterioration and allows for some storage. They are also suitable for stocking, so please purchase them for your stock.


Ergonomically designed for efficient pulling with no waste. Ergonomically designed for efficient pulling with no waste.
It can be attached to the tip of a general slide hammer or chain block and can pull out large dents all at once.
A major feature of our 6-claw and 7-claw hooks is that they do not have rubber spacers between the claws, making them a professional-oriented product that allows for relatively easy fine-tuning and arrangement of claw pitch.


They are 100% compatible with our flat washer 100-piece set (sold separately), so please use them.



"Notes" Specifications and designs may vary slightly depending on the arrival time and lot.
Thank you for your understanding.
The color may differ slightly from the image due to the display environment.
Thank you for your understanding.
We are not responsible for any accidents or damages resulting from the use of this product.
Thank you for your understanding.
Instruction manual and warranty are not included.

This is a set of 100 copper-plated flat washers used for welding to dented steel panels during automobile sheet metal work and pulling them out all at once with a slide hammer or other tool.
It welds well with good electrical conductivity, is less prone to back burning, and adheres well to high-strength steel and ultra-high-strength steel.
Ideal for pulling out dents except in areas with complex press lines.

Since it is copper-plated, it is resistant to rust even when stored and maintains a good condition. It also adheres firmly to the panel during welding.
With a set of 100 pieces, you have a large quantity, so you can perform satisfactory pulling without worrying about the number of pieces.

The hole size is just right to fit the claws of a general slide hammer.
Another notable feature is that the tip is triangular, designed for a smaller welding area on the panel.

Size (approx.): Total length 59mm, Thickness 2mm, Weight 9g (per piece), Hole size 10mm x 17.5mm, Set of 100 pieces
*Specifications and designs may vary slightly depending on the arrival time and lot.
Thank you for your understanding.
The color may differ slightly from the image due to the display environment.
Thank you for your understanding.

2025/12/01 17:59:48#95316b712723439ea7e2cb6c18f45b5cdbb20f1e