"Usage Method"
There is a front and back to the gasket.
Please set it so that the round mark is visible.
If you mistake the front and back, the cap cannot be tightened, which can cause leaks.
Insert the straw mouthpiece by screwing it in from underneath the cap.
Pinch the tip of the straw mouthpiece and pull until it clicks into place.
Insert the straw tube into the straw mouthpiece.
How to set (gasket) Please tighten the cap firmly.
Insufficient tightening can cause leaks.
How to set (straw) Rotate the straw food to open and close it firmly until you hear a "click" sound.
If the opening and closing of the straw food is insufficient, it can cause leaks.
Handling of the straw food When removing the straw food, attach the side with the dent to the straw side.
Handling of the handle Open the handle first, then remove the bottle and cap.
If the handle is left closed, the bottle cannot be attached or detached.
When opening the handle, turn it until it clicks to fix it in place.
Do not attach or detach the bottle and cap with the handle closed.
The handle or bottle may be damaged.
Precautions when drinking Do not tilt the bottle level or above while the straw food is open.
The contents inside may spill from the straw or vent holes.
Caution about cleaning Be sure to clean before first use.
Colored drinks such as fruit juice, tea, or milk may leave odors or stains on the straw and gasket, so after use, soak in lukewarm water and wash thoroughly with dish soap.
Disinfection and sterilization methods
【Boiling Disinfection】
Fill a large pot with plenty of water and boil for 3-5 minutes after boiling.
If you do not boil with plenty of water, there is a risk of deforming the edge of the pot.
Excessive boiling can damage the product prematurely.
Since boiling uses hot water, be especially careful when children are nearby.
【Chemical Disinfection】
Use only disinfectants specifically for bottles and nipples for chemical sterilization.
Please follow the instructions for the disinfectant carefully.
【Steam Sterilization】
Use a bottle-specific steam sterilizer or similar device.
Please follow the instructions for the sterilizer carefully.
"Components"
Bottle, straw food, cap, handle fixing pin: Polypropylene
Handle, handle fixing pin: Polypropylene, thermoplastic elastomer
Gasket, straw mouthpiece, straw tube, vent parts: Silicone rubber

"Precautions for Use"

Do not tilt the bottle level or above while the straw food is open.
The contents inside may spill from the straw or vent holes.
Do not place near fire.
Do not put hot drinks inside.
Do not heat drinks in the microwave.
Do not put in the freezer as it may cause damage.
Microwave steam sterilization is not possible.
Microwave failure or high temperatures beyond the heat resistance may cause deformation or damage.
Silicone rubber has a natural raw material odor and easily absorbs surrounding odors, but there is no problem with quality.
Parts are not compatible with anything other than "Pigeon Petit Straw Bottle".
To use properly... Caution about leaks
Ensure the gasket is set firmly and the straw food is securely closed, or it may cause leaks.
This product is designed to be leak-resistant, but leaks may occur if carried diagonally, sideways, upside down, or if subjected to vibrations.
Also, if you put in hot or cold drinks, or carbonated beverages, changes in temperature and pressure may increase the internal pressure of the bottle, causing contents to come out from the tip of the straw mouthpiece.
Leaks may occur under various conditions, so please put it in a waterproof bag or similar when carrying.
"Contact Information"
Company Name: Pigeon Corporation Customer Service
Reception Hours: 9:00-17:00 (excluding Saturdays, Sundays, and holidays)
"TEL"
Phone: 0120-741-887
"Manufacturer and Distributor"
Pigeon Corporation

"Address"
4-4 Honmatsu-cho, Nihonbashi, Chuo-ku, Tokyo 103-8480

"Country of Origin"
Indonesia