The Pigeon "Mother's Milk" bottle is designed with over 60 years of research to pursue a "natural feeding" experience.

Babies can drink using their natural mouth movements from birth, making it easy to alternate between breastfeeding and bottle-feeding, allowing you to continue breastfeeding with peace of mind.

* Comes with a Mother's Milk teat, size M (three-cut), for use from 3 months.
* Supports the three principles of feeding: "Latching," "Sucking," and "Swallowing."
* "Latching" support: A soft, chewy texture that mimics the breast and doesn't hinder the tongue's natural movement.
* "Sucking" support: A snug-fitting curve that seals to the baby's mouth, with a "Latch-On" guide for proper positioning.
* "Swallowing" support: A nipple hole shape designed to adapt to the baby's growth and development.
* No. 1 in use at maternity hospitals and clinics (※Pigeon survey).
* The plastic is high-quality, medical-grade material. It is also BPA-free and made from safe materials.

**How to Use**

**Sterilization Methods**
Boiling: Yes / Microwave: Yes / Chemical: Yes

**Bottle Capacity**
240ml (maximum graduated capacity)

**Nipple Hole Shape**
Three-cut (M size)

**Ingredients**
Hood and Cap: Polypropylene
Nipple: Synthetic rubber (silicone rubber)
Bottle: Polyphenysulfone (PPSU)

**Precautions for Use**
* Please keep the instruction manual in a safe place.
* After use, thoroughly wash the nipple and bottle with a dedicated brush and then sterilize them.
* Do not place near fire, as it may cause deformation.
* Use a sponge brush for cleaning. Using a hard brush may cause scratches.

**Caution: Burns**
To prevent burns, please be aware of the following:
* The feeding bottle will become hot during milk preparation.
* Do not prepare milk near the baby.
* Always check the temperature of the milk or drink before feeding.
* The feeding bottle will be hot after boiling or microwave sterilization.
* When preparing milk, shaking the bottle vertically can cause the contents to spurt out, posing a burn risk. Also, if you shake with the hood attached, the high temperature of the water can increase the internal pressure of the bottle, leading to leakage or spurting, which is dangerous.
* When holding the bottle by the hood attached to the cap, the hood may come off. Hold and support the bottle from the upper part.

**Notes on Assembling the Nipple Set**
(1) Hold the base of the nipple firmly, as if squeezing it.
(2) Insert one side of the nipple base into the cap from above.
(3) Use both thumbs to fit the entire nipple base inside the cap.

**The nipple for this feeding bottle can only be used with the following products:**
* Pigeon Mother's Milk Feeding Bottle
* Pigeon Mother's Consultation Feeding Bottle
* Pigeon Mag Mag Colon Spout

* The cap and hood of this feeding bottle cannot be used with the Pigeon Mag Mag Colon Spout.
* Slim type nipples cannot be used with this feeding bottle.

**About Cleaning and Sterilization Methods**
* Always wash and sterilize before first use.
* After use, immediately soak in lukewarm water and wash with "Pigeon Bottle Cleaner" or similar. Thoroughly wash the nipple and bottle with a dedicated brush and then sterilize.
* After washing, rinse thoroughly with clean water.
* Gently rub the air vent valve, air vent hole, and nipple hole with both hands. Washing or pulling strongly can tear the valve and cause leakage.
* To protect the air vent valve, a safe white powdery food additive is applied. Also, due to the nature of the material, some components may seep out. While safe, please wash before use.
* The tip of the nipple is very delicate. When washing with a cleaning brush, hold the tip of the nipple with the pad of your finger.

**[Boiling Sterilization]**
Boil in plenty of water for 3-5 minutes after it comes to a boil.

**[Chemical Sterilization]**
Refer to the instructions for the sterilizing solution.

**[Microwave Sterilization]**
Refer to the instructions for the microwave sterilizer.

**Recommended Replacement Interval**
* Once a baby gets used to a particular nipple, they may resist switching to a new one. Use two or more nipples alternately for approximately 2 months. Replace them sooner if they become worn, regardless of usage frequency, to prevent tearing or damage.
* Be aware that nipples can tear if a baby with emerging teeth bites and pulls on them.

**[Country of Origin]**
China

**[Contact Information]**
Company Name: Pigeon Corporation, Customer Service Center
Phone: 0120-741-887
Reception Hours: 9:00 AM - 5:00 PM (excluding Saturdays, Sundays, and public holidays)

**[Manufacturer and Distributor]**
Company Name: Pigeon Corporation
Address: 4-5 Nihonbashi Hisamatsu-cho, Chuo-ku, Tokyo 103-8480

**[Product Classification]**
"Daily Goods"

* Please note that package design and other specifications are subject to change without notice.