Code: 4902901917721

Brand: Mitsubishi Electric

Specifications: VL-06JV3

Product color: None

About this product
Quantity (units): 1 br Connection pipe (mm): φ100 br Usage: Living room br Suitable area: 6 tatami mats (9.9m2) br Semi-cold region Warm climate specification br Applicable region: South of Energy Conservation Standard Region 4 (not for use in cold regions) br 24-hour ventilation br Quick-connect terminal connection br Compact main body design br Paper-made total heat exchanger br Model setting by tatami mat size br Two-stage switch: "High" and "Low" br Wall-mounted only
› See more Brand Mitsubishi Electric
Features Energy efficiency
Color: None
Indoor/outdoor use Indoor, outdoor use
Power Power cord type About this product
Quantity (units): 1 br Connection pipe (mm): φ100 br Usage: Living room br Suitable area: 6 tatami mats (9.9m2) br Semi-cold region Warm climate specification br Applicable region: South of Energy Conservation Standard Region 4 (not for use in cold regions) br 24-hour ventilation br Quick-connect terminal connection br Compact main body design br Paper-made total heat exchanger br Model setting by tatami mat size br Two-stage switch: "High" and "Low" br Wall-mounted only
› See more

Shipping size: Height 49.3, Width 30.4, Depth 24.7

Shipping weight: 3530

Product introduction

Quantity (units): 1
Connection pipe (mm): φ100
Usage: Living room
Suitable area: 6 tatami mats (9.9m2)
Semi-cold region Warm climate specification
Applicable region: South of Energy Conservation Standard Region 4 (not for use in cold regions)
24-hour ventilation
Quick-connect terminal connection
Compact main body design
Paper-made total heat exchanger
Model setting by tatami mat size
Two-stage switch: "High" and "Low"
Wall-mounted only
Power switch (located on the upper right side of the main body)
High/low switch (located on the upper right side of the main body)
Sliding shutter installed (at the back of the main body) Manual type
Operation possible in cold conditions (exhaust-only mode: close the intake shutter and exhaust only)
Antibacterial specification (main body panel)
Low noise, low power consumption
Supplementary cartridge installed
Direct outlet plug replacement cord (P 01DC, P 250DC) can be attached
Allergy sterilization filter installed
Voltage (V): 100
Power supply (φ): Single-phase
Optional: high-performance dust removal filter, ultra-fine particle filter
Optimal for energy-saving measures for heating and cooling in 24-hour ventilation.
Not suitable for vertical installation
Not suitable for ceiling installation
Outdoor hood pipe sold separately
Not moisture-resistant; do not use in bathrooms, washrooms, etc.
Use in combination with specified system components
When outdoor air temperature is low, or during snow, wind, heavy rain, especially fog or powder snow, water and snow may enter along with intake, causing water leakage. Stop operation and close the shutter. Do not operate outside the above conditions or during cleaning and inspection.
Using in environments where the panel and internal parts may condense or freeze (outdoor temperature 5°C or below, indoor temperature 15–25°C, indoor humidity 45% or higher). Use in "Cold operation" mode around outdoor temperature 5–10°C.
The standard filter may allow some small particles or insects to pass through. For higher collection efficiency, it is recommended to use the separately sold high-performance dust removal filter (P 70HF2).

Caution Disclaimer Please read

Installation requires electrical work and a qualified electrician. Have a qualified professional install. Check the installation status before use.