**Usage Instructions**
● For hot water supply and bath boiler types (single-hole and two-hole):
Use water at approximately 40°C or leftover bath water.

*It can also be used with leftover bath water containing bath additives.*
(Depending on water quality and water pressure, foam may be less abundant or foam longevity may be shorter.)

(1) Add water to the bathtub and put in this product.
If there is little leftover water, add water and evenly pour this product across the water surface.
(For bath boiler types (those with reheating function), reheat for 5-10 minutes before adding small items.)
If the cover or filter attached to the holes is removable, remove it beforehand.

*For water volume:*
- For hot water supply types (faucet pouring), fill to about 6-7 tenths.
- For bath boiler types (single-hole or two-hole), about 3 cm from the top hole.

(2) Foam and soak small items
Turn on the shower or faucet fully for about 10 seconds, spray water vigorously onto the water surface to create foam, then place bathroom items such as a chair, washbasin, bath lid, or plastic toys into the bath and soak overnight (8-12 hours).

(3) Wash small items
Remove the small items and rinse with water.
If dirt remains, lightly scrub with a sponge or similar.

(4) Clean the bathtub and bath boiler
After draining and rinsing with water, add water or hot water again up to about 5 cm above the holes and clean the bath boiler.

- For single-hole (forced circulation boiler) types:
Run reheating operation for about 5 minutes, then drain and thoroughly rinse the bathtub with water.

- For two-hole (natural circulation boiler) types:
Insert a hose into the lower hole, forcefully spray water to wash out dirt inside the boiler, then drain and rinse the bathtub thoroughly with water.

*Note:* The bag has a hole at the top to prevent it from swelling.

To keep the bathtub and bathroom items clean, it is recommended to use regularly every 1-2 months.

**For Jet Baths, 24-Hour Baths, and EcoCute (Heat Pump Water Heaters):**
Usage methods may vary depending on the model or may not be applicable. Please refer to the instruction manual or contact the manufacturer.

*When using in a jet bath, stop if foam is about to overflow.*

**Ingredients**
Alkaline agent (carbonates), bleaching activator (percarbonate), chelating agent (EDTA salts), surfactant (2% alpha olefin sulfonate sodium), fragrance.

**Precautions for Use**
- Always follow the usage instructions and do not use for purposes other than intended.
- Use immediately after opening.
- Do not leave overnight.
- Do not bathe during cleaning.
- People with sensitive skin should wear rubber gloves.
- Prevent powder or liquid from getting into eyes.
- Do not combine with other detergents.
- Keep out of reach of children and pets.
- In old boilers, scale or rust may clog pipes or rubber parts, temporarily stopping water leakage; using this product may clear the clog and cause water leakage.

**First Aid Measures**
- If cleaning solution contacts skin, rinse thoroughly with water.
- If inhaled as powder, breathe fresh air and consult a doctor if abnormal symptoms occur.
- If swallowed, give water or milk to drink, and if it gets into the eyes, rinse thoroughly immediately.
- In all cases, seek medical advice promptly.

**Contact Information**
**Customer Service**
Phone: 0077-788-555

Hours: 9:00–17:00 (excluding Saturdays, Sundays, holidays, and our designated days off)

**Manufacturer**
Fumakilla Co., Ltd.

**Address**
11 Kanda Mikuracho, Chiyoda-ku, Tokyo 101-8606, Japan

**Country of Origin**
Japan

**Product Category**
Daily necessities

*Note:* Package design and other details are subject to change without notice. Please understand.