Because it has a 90-degree right-angle structure, it can be attached across both sliding doors and pillars.
While general straight latches can only be attached to a flat surface, this product can be installed at corners where sliding doors meet pillars, or opening doors meet door frames.
It can be retrofitted to locations where latches were previously impossible, such as unlocked interior sliding doors, bathroom or washroom doors, and around windows.
It can be locked and unlocked with a simple operation of pushing down the knob with your finger.

"Ambidextrous design usable for both left and right opening x fine adjustment with sliding" The main body's latch is designed to be used on either the left or right side, allowing installation regardless of the door's opening direction.
Furthermore, the central sliding stopper piece moves left and right along the elongated hole, allowing for fine adjustment of the catching position to fit the gap between the door and the frame.
When the gap is "just a few millimeters" off due to variations in the door, the position can be adjusted by sliding instead of re-drilling pilot holes, reducing the effort required.

"Stainless steel x 1.8mm plate thickness, chamfered edges" The material is stainless steel, which is resistant to rust and discoloration, even in humid bathroom or washroom environments.
The plate thickness is 1.8mm, which is suitable for use as an auxiliary latch for interior sliding doors, windows, and light wooden doors.
The edges and corners are chamfered to soften the impact on areas touched by fingers.
The surface has a calm hairline finish that blends well with doors.

"Set of 2 for two locations, choose from 4 colors x 2 sizes to match your doors" One set includes 1 main body (90-degree latch), 1 keeper, and 4 tapping screws, and this comes as a set of 2.
It can be used to secure two locations on a single door, or to install in two rooms.
Colors available are silver, black, copper, and bronze (4 colors), and sizes are S (keeper 5cm) and M (keeper 7cm) (2 sizes).
You can choose colors that easily match wooden doors or white doors.

"Product Specifications" Material: Stainless Steel / Plate Thickness: 1.8mm / Color: Black / Size: S (Main Body 4.2x3cm, Keeper 5x2cm) / Set Count: 2 pcs (1 pc = Main Body + Keeper + 4 Tapping Screws) / Surface Finish: Hairline, Chamfered / Orientation: Ambidextrous / Suitable for: Interior sliding doors, opening doors, windows, bathroom doors, etc.
"Precautions" Since it is fixed by screwing directly into the pillar or door with the included tapping screws, pilot holes and installation marks will remain (please check carefully for rental properties).
The included screws are short, so their grip may be weak on doors with thin decorative panels or hollow doors. In such cases, please prepare longer screws that match the thickness of the installation surface.
As it is an auxiliary latch with a plate thickness of 1.8mm, it is not suitable for use as the main lock for heavy exterior doors such as entrance doors.

2026/09/10 9:50:28#7ca0d3ed835b7fc8521636e388b4cdd420fddea1