Code: 4960652888523

Brand: Daiwa (DAIWA)

Model: 888523

Product color: Black & Orange

Main body weight (excluding batteries and accessories): approximately 70g
Uses dry batteries (sold separately): 2 AAA batteries
› See more Main body weight (excluding batteries and accessories): approximately 70g
Uses dry batteries (sold separately): 2 AAA batteries
› See more

Shipping size: Height 14.1, Width 12.4, Depth 2.3

Shipping weight: 90

A needle tying device with a grip-friendly pistol shape, about 26mm thick.

Grip-friendly pistol-shaped design
Can wind approximately 500 needles (assuming 5 winds per operation)
Easily ties small needles as well
Compatible thread: Nylon, Fluoro, 0.1, size 6 (thin threads may curl) Brand introduction


Leading the world, DAIWA promotes "Feel Alive. Experience the best moments." and continues to drive popular fishing, covering a wide range of target fish. Due to its high technical skill, it manufactures and sells a variety of fishing gear including reels, rods, lures, apparel, and accessories. It also provides valuable natural experience opportunities through the "Daiwa Young Fishing Club" for children supporting the future.


PICK UP

Access the store


Cooler box feature

Access the store


WEAR

Access the store


Tackle box feature

Access the store


Line feature

Access the store


Beginner lure fishing feature

Access the store


Shore jig feature

Access the store


Aji and Mebaring feature

Access the store


Impact feature

Explanation by manufacturer
How to use

Needle set

1. Move the slide part to the lower position until it clicks.

2. Press the hook set button to open the hook set and set the needle.

3. While pressing the needle, return the hook set button to fix the needle in place.

Be careful: if you release your hand from the needle while the hook set is open, the needle may fly out. After fixing with the hook set, press the needle further with your finger to securely fix it inward.

Thread set

4. Leave 4-6cm of thread and firmly clamp it into the thread holder all the way to the back.

The thicker the thread or needle, the longer it remains. If the remaining thread is short, you may not be able to tie the needle. Also, if it is too long, it may get caught in the gears, so be careful.

5. Follow the thread groove to bring the thread to the back, then pass it from the bottom to the front.

6. Reroute the thread along the right side of the needle into the thread groove and bring it to the back.

7. Place the lower thread over the slide part.

8. Keep the thread coming out the back taut without slack.

Needle tying

9. While keeping the back thread taut, turn the switch to "ON" and rotate the gear 4-5 times to tie the thread.

10. Check the tied thread. If the knot is twisted or uneven, tighten the thread tension.

Tightening

11. Move the slide part upward along with the thread. If it stops tilted, the thread may come off the slide part.

12. Pull the thread on the back side of the main body in the direction of the arrow until the knot is complete.

Pulling too hard may damage internal parts.

13. From the back side of the main body, pass the thread to the front side and also remove the thread from the thread holder.

14. Press the hook set lever to remove the needle.

15. Pull both ends of the thread and tighten securely. Cut the thread to the necessary length.

Ensure the finished needle does not come loose before use.