Notes
We are not responsible for any accidents or damages resulting from the use of this product.
Please understand this in advance.

Instruction manual and warranty card are not included.

The load capacity of 5kg applies only when installed on sturdy wood or stone materials.
When installed on other materials, the load capacity is less than 5kg.
Please be careful.


*The design of the anchor plug may vary slightly depending on the arrival time.
Specifications and design may change slightly depending on the arrival time and lot.
Please understand this in advance.
Due to display environment, there may be slight differences in color and appearance from the images.
Thank you for your understanding.

*Installation in humid places such as bathrooms requires some caution.
The surface is stainless steel, but the base and screws under the cover are made of steel.
For installation in humid places, it is recommended to apply rust prevention treatment here.

A set of 6 wall hooks made of stainless steel, which is resistant to rust.
Unlike sticker-type hooks, they are fixed using longer M4x20 screws at three points.
Different load capacity from sticker-type hooks.
Can hold up to 5kg.
With washers included, the part where the screw is fixed is hidden, so it does not spoil the appearance.


This product is in matte black (a black color with a matte finish).
Simple yet timeless design.
Suitable for living rooms, bedrooms, closets, kitchens, as well as bathrooms, dressing rooms, washrooms, toilets, and even outdoor areas exposed to rain and wind, thanks to stainless steel that does not rust.
You can also use it in changing rooms, fitting rooms, companies, schools, club rooms, restaurants, izakayas, beauty salons, and more, depending on your ideas.
When used together with a hanger, it is sturdy enough to easily hang coats and similar items.
The secret to the 5kg load capacity is dispersing the load to three points using relatively thin and long screws, rather than supporting with thick, short screws.
Because the screws are thin, they are less likely to leave marks after removal.


How to use anchor bolts necessary for attaching to hard walls.

Use a pencil to mark the wall above the base screw hole where you want to install.

Use a drill or a pin to make a hole in the wall based on the mark.

Once the hole is made, drive the anchor bolt into the wall using a hammer or similar tool.

Tighten the screw on the base onto the anchor using a Phillips screwdriver.
Then attach the cover and tighten the pole from above.

The current anchors are white.



The pole mounting screw is a right-hand thread.
Tighten clockwise, loosen counterclockwise.

The pole tightening bolt on the base is an M8 size right-hand thread.

Tighten clockwise, loosen counterclockwise.
This is a load-bearing part, so please tighten firmly until the end.


Illustration of the assembly after attaching the base to the wall.

Illustration of installation method that does not use anchor bolts.

There is no need to drill holes in the wall or drive in anchor bolts.

The necessary tools are just a Phillips screwdriver (a pencil and a drill are optional but more convenient). First, determine the installation position with a pencil, then lightly drill a hole at the screw-in point with a drill or a pin.
This allows the screw to go straight into the wall or pillar, making installation cleaner.



Using the included anchor bolts (expansion plugs and wall plugs), it can be used on concrete walls, stone walls, and other surfaces besides wooden walls.
You can easily install the wall hook with minimal tools.
Using just a Phillips screwdriver, a drill, and a drill, you can easily attach it to the wall.


There may be burrs.

If concerned, please remove burrs with a file or similar tool.

To prevent injury, it is recommended to wear work gloves during installation.

2025/06/14 0:50:35#ac6e31ce5dd8e48316625ee171f8acceb15c70f1